Here are a few of the features of the piece that may not be obvious from watching the videos or photos.
Each Caribou flaps it's wings at a different rate than the others.
There are two adult and one juvenile Caribou as identified by the size of their antlers.
The body of each Caribou has a degree of striking on the the surface to represent their fur/hair.
This piece was designed with a more open concept to the base. In this way the mechanism is easier to view, and the piece seems "lighter" or more "airy" in keeping with with the flying motif.
The fir trees are actually "knock-offs" of LEGO trees borrowed from my grandson's collection.
The crank can be turned in either direction since no complex mechanism exists in this piece.
Feet were added to the bottom of the base to allow for a more comfortable crank handle length and clearence.
Six fasteners into the bottom of the pillars can be released to service the piece by removing to top section in future if necessary.
Dimensions: 19" tall X 18" wide X 10" deep. (48.3 X 45.7 X 25.4 cm) Weight: 5.5 lb. (2.5 kg.) Number of Pieces:204 Materials of Construction: Box - Birch Plywood, Wing Harness - Poplar, Cams/Gears - Birch Plywood, Caribou- Birch, Pine, and Basswood Trees - Birch Plywood & Dowel
Tundra Trees like LEGO!
I felt that adding some small trees might enhance the illusion of flying. In the tundra trees are a rarity and if present they are mostly mere scrub! I bent the rules a bit and created these dwarf conifer trees. It is a clear case where you should paint as much as you can before assembling. If you play with LEGO products you may recognize where the design is taken from.