It's a Hive of Activity Here...

Well the bees are basically complete. The bees are made of several pieces depending on their movements. Many are partially hidden in the honeycomb so they are not a complete bee. in these cases the movement actuator protrudes out of the rear of the bee to link to the mechanism. 

The abdomens, when present, are made from a basswood block that tapers to a stinger in the back end. Some examples, already painted with a base coat of yellow, are shown in the two photos below. The centre piece of  bee bodies are made from 1-1/4" wooden balls, purchased as project parts from a local tool store. You can see two complete ones painted white below. They are stuck together with the abdomen using a 1/8" dowel for strength.  A small flat was sanded on each piece for an additional gluing surface.

In some other cases the bees have only half an abdomen. This was done by cutting on of the 1-1/4" balls in half on my scroll saw. This takes great care as it is a genuine finger cutting risk! I sand the cut face smooth and dowel it into the other end of the abdomen. In these cases the bees are in the honey comb and there is a block shaped to fit the bottom cell profile to secure them in place.  The photos show two configurations like this. one in the foreground of the photo on the left has a slot cut through it with an rocker arm that pivots of a pin. This bee when completed will bounce it's butt and down.  The other, a little to the right of the other slides in and out of the block. 

As mentioned previously  the legs are made from copper wire inserted in holes drilled in the abdomen and thorax and secured with CA glue.

A collection of partially completed bees.

Same bees, different angle!

rods attached as antennae. Those that don't move are attached to the thorax with a dowel. Those that move have specific connections to allow for their movements, either up and down, side to side or spinning. Here are some examples in the photos below. 

Bees with heads that bob up and down

Bees with heads that move side to side.

A wing Flapping Bee!

Where the heads In these photos you'll notice it is hard to see the bees eyes. I decided I go for a more natural, realistic look rather than cartoon coloured white eyes with black pupils, although they can be made more expressive. For now I am staying with a natural look, but that could change!

Well that's all for now, more on the bees and comb later!